EZ- LITE1Solid Seat with EZ-Lite Hardware
Pg. 1 price booklet

Standard solid seat with (2) each #504 frame clamps and (2) each #436 30° clamps. This seat can only be cut full width and has no ability to be angle adjustable. Mounts flat on top of the seat rail. Clamps fit 1" round tubing only. 3" growth can be added to this seat. Seats are cut full width with 2" wide X 2" deep back post notches unless otherwise specified.




EZ- LITE 1EXT Solid Seat / Extended EZ-Lite Clamps
Pg. 1 price booklet

Same as above with 2" long EZ-Lite clamps.

TWIST1Solid seat with Twister Hardware
Pg. 1 price booklet

Standard solid seat with (2) each #494 frame clamps and (2) each #436 30° clamps. These clamps will fit only 1", 7/8" or 3/4" round tubing. This hardware allows changes in the seat to back angle and when used with EE2 or TWIST2 back, will allow the system to be tilted within the chair frame. 3" growth can be added. Seats are cut full width with 2" wide X 2" deep notches unless otherwise specified.

 

Snap-Lock1Solid Seat with Snap-Lock Hardware
Pg. 1 price booklet

Standard solid seat with (2) each #494 Snap-Lock frame clamps and (2) each #436 30° clamps.