EE2 Solid
Back with ECONO-EZE Hardware
Pg. 2 price booklet
Standard solid back with (2) each #462 frame clamps andƯ (2) each
#437A back mounting forks. Each frame clamp comes with
the ability to fit 1", 7/8" or 3/4" round tubing. Special
clamps are available to fit most non-round tubing. This
hardware allows you to manipulate the seat to back angle
and when used with EE1 or TWIST1 seats will allow the system
to be tilted within the chair frame. Backs are cut to fit
between the back posts, unless otherwise specified.
EE2SLSolid
Back with ECONO-EZE Spring
Pg. 2 price booklet
Same as
above with (2) each #515 spring loaded back mounting forks.
EE2-LTSolid
Back with ECONO-EZE LITE Hardware
Pg. 2 price booklet
Same
as EE2 with #437F ECONO-EZE LITE back mounting forks
replacing the #437A back mounting forks.
EE2-No
Hardware- Solid Back with No Hardware
Pg. 2 price booklet
Same EE2
solid back without mounting hardware.
EE2
MicroSolid
Back with Micro Hardware
Pg. 2 price booklet
Same
EE2 solid back with Econo-Eze Micro mounting hardware. Only
available on seating systems of 14" wide and under.
EE2 Micro-LTSolid
Back with Micro Lite Hardware
Pg. 2 price
booklet
Same
EE2 Micro solid back with #437G Econo-Eze Micro Lite mounting
hardware. Only available on seating systems of 14" wide
and under.
TWIST2Solid
Back with Twister Hardware
Pg. 2 price booklet
Standard solid back with (2) each #494 frame clamps. These clamps
will fit 1", 7/8" or 3/4" round tubing. This hardware
allows changes in the seat to back angle and with EE1
or TWIST1 seats will allow the system to be tilted within
the chair frame. Backs are cut to fit between the back
posts, unless otherwise specified.
|
